EV — Battery Packs
Cell-to-module TIM between cells and cooling plate
Non-silicone avoids battery electrolyte contamination and fills gap tolerance reliably.
High-conductivity flexible pad, non-silicone
TC ≥ 2.0 W/m·K, 1–3mm thick, non-silicone
HIGH DEMAND
EV — Battery Packs
Gap filling liquid for complex module geometry
Liquid fills irregular shapes — easier for automated EV battery assembly lines.
Dispensable liquid gap filler
TC 2–3.5 W/m·K, dispensable
HIGH DEMAND
EV — Inverter / OBC
IGBT module to heatsink
High TC plus electrical insulation is critical for inverter IGBTs and stays vibration-stable.
Glass-reinforced insulating pad
TC ≥ 4.0 W/m·K, insulating, glass reinforced
HIGH DEMAND
EV — Inverter / OBC
IGBT / phase change
PCM keeps bond lines thin with zero pump-out under vibration.
Ultra-thin phase change sheet
TC ≥ 5 W/m·K phase change
HIGH DEMAND
Electronics — LED Lighting
LED chip to heatsink bonding
Tape replaces mechanical fasteners for fast, high-volume LED assembly.
Thermal bonding tape
TC ≥ 0.8 W/m·K, strong adhesion
HIGH DEMAND
Electronics — SMPS / Power
Transformer / capacitor to housing
Fills air gaps and absorbs vibration in power supplies.
Soft compressible gap pad
TC 1.0–2.0 W/m·K, compressible
MEDIUM-HIGH DEMAND
Electronics — Consumer
Laptop / tablet CPU TIM
OEM-tier compounds keep thermal resistance minimal on tight stack-ups.
Low-viscosity grease or ultra-thin PCM
Thin bond line, ≥5 W/m·K
MEDIUM DEMAND
Telecom — 5G Base Stations
Radio Unit (RRU) thermal pad
5G RRUs need tight tolerances — ULM pads fill without stressing components.
Ultra-low-modulus conformable pad
TC ≥ 3.5 W/m·K, ultra low modulus
HIGH DEMAND
Telecom — Networking
Switch / router IC cooling
Insulating pads isolate the PCB from the heatsink chassis safely.
Electrically insulating pad
TC 1.5–3.0 W/m·K, insulating
MEDIUM DEMAND
Industrial — Drives & Inverters
VFD / servo drive IGBT
Trusted in industrial automation BOMs for stable long-term performance.
Glass-reinforced insulating pad
TC 2.5–6.0 W/m·K, insulating, heat-cycle stable
MEDIUM DEMAND
Industrial — Solar / UPS
IGBT in solar inverter
Solar inverters face wide temperature swings — PCM or stable pads handle the cycling.
PCM or high-TC pad
Wide outdoor temperature range
MEDIUM-HIGH DEMAND
Medical Devices
MRI, diagnostics, imaging power supply
Medical applications require high dielectric strength and certified materials.
High-dielectric insulating pad
Polyimide / high dielectric, certified material
LOW-MEDIUM DEMAND